Results of the summarizing process for the arXiv paper: 2109.06447v1

This study investigates the 1/f noise of the Five-hundred-meter Aperture Spherical Telescope (FAST) receiver system using drift-scan data from an intensity mapping pilot survey. The FAST has a very large aperture and is equipped with multiple feeds and receivers, making it ideal for conducting large surveys. The observations were carried out with the L-band 19-beam feed system and the associated cryogenic receiver. All the 19 beams have 1/f fluctuations with similar structures, which can be important for HI intensity mapping. The data used in this work was collected by the FAST Hi intensity mapping pilot experiment during risk-shared observations made in May 2019. Five strips spanning 125◦ < R.A. < 325◦ and 25.4◦ < Dec. < 26.7◦ were drift scanned in five consecutive days; each strip observed for 13.3 hours with a frequency range from 1.0 GHz to 1.5 GHz. Both temporal and two-dimensional power spectrum densities were estimated, showing that correlations directly seen in the time series data at low frequency $f$ are associated with sky signal, likely due to a coupling between foregrounds and system response. To remove foregrounds, Singular Value Decomposition (SVD) was used to subtract the strongest components of measured noise power significantly reducing it by up to twenty modes subtraction; thus reducing knee frequency of noise in a ten MHz band to $1.8 \times10^{-3}\Hz$, well below thermal noise over a scale of five hundred seconds. The two-dimensional power spectra showed that variations restricted to a small region in time-frequency space could be suppressed with SVD mode subtraction; hence residual uncorrelated noise after SVD mode subtraction was uncorrelated in frequency as well. A simple noise diode frequency-independent calibration of receiver gain at eight second intervals did not affect results as the 1/f noise had a knee frequency of $(f_{k}) \sim$ 6 $\times$ 10$^{-4}$Hz and time and frequency correlation spectral indices $(\alpha) \sim 0.65$, $(\beta) \sim 0.8$ after SVD subtraction of thirty modes respectively . The study concluded that residual 1/f noise can bias HI power spectrum measurement by up to ten percent; making it important to consider in HI intensity mapping experiments conducted using FAST receiver systems . The results were discussed in detail in section five while section six summarized findings providing valuable insights into characterization and mitigation of 1/f noise crucial for current optical surveys .

• - The study investigates the 1/f noise of the Five-hundred-meter Aperture Spherical Telescope (FAST) receiver system using drift-scan data from an intensity mapping pilot survey.
• - The FAST has a large aperture and is equipped with multiple feeds and receivers, making it ideal for conducting large surveys.
• - The observations were carried out with the L-band 19-beam feed system and the associated cryogenic receiver.
• - All 19 beams have 1/f fluctuations with similar structures, which can be important for HI intensity mapping.
• - Data was collected by the FAST Hi intensity mapping pilot experiment during risk-shared observations made in May 2019.
• - Both temporal and two-dimensional power spectrum densities were estimated, showing that correlations directly seen in the time series data at low frequency $f$ are associated with sky signal, likely due to a coupling between foregrounds and system response.
• - To remove foregrounds, Singular Value Decomposition (SVD) was used to subtract the strongest components of measured noise power significantly reducing it by up to twenty modes subtraction; thus reducing knee frequency of noise in a ten MHz band to $1.8 \times10^{-3}\Hz$, well below thermal noise over a scale of five hundred seconds.
• - A simple noise diode frequency-independent calibration of receiver gain at eight-second intervals did not affect results as the 1/f noise had a knee frequency of $(f_{k}) \sim$ 6 $\times$ 10$^{-4}$Hz and time and frequency correlation spectral indices $(\alpha) \sim 0.65$, $(\beta) \sim 0.8$ after SVD subtraction of thirty modes respectively .
• - Residual 1/f noise can bias HI power spectrum measurement by up to ten percent; making it important to consider in HI intensity mapping experiments conducted using FAST receiver systems.
• - The study provides valuable insights into characterization and mitigation of 1/f noise crucial for current optical surveys.

The study looked at how the Five-hundred-meter Aperture Spherical Telescope (FAST) receiver system makes noise. FAST is a big telescope that can look at lots of things. They used a special tool to collect data from the telescope in May 2019. The data showed that there was some noise in the telescope's signals, which could make it hard to see what they were looking for. Scientists found a way to remove some of this noise so they can see better. This study helps us understand how telescopes work and how we can make them work even better. Definitions- Aperture: an opening or hole through which light travels - Fluctuations: changes or variations in something over time - Correlations: connections or relationships between different things - Foregrounds: objects or signals that are closer and easier to detect than the thing you're actually trying to observe - Spectral indices: measurements used to describe patterns in data over different frequencies

Exploring the 1/f Noise of FAST Receiver System Using Drift-Scan Data from an Intensity Mapping Pilot Survey

The Five-hundred-meter Aperture Spherical Telescope (FAST) is a very large telescope equipped with multiple feeds and receivers, making it ideal for conducting large surveys. In May 2019, the FAST Hi intensity mapping pilot experiment was conducted to investigate the 1/f noise of the receiver system using drift-scan data. This article will explore the findings of this research paper and discuss its implications for current optical surveys.

Background Information

The FAST Hi intensity mapping pilot experiment used five strips spanning 125◦ < R.A. < 325◦ and 25.4◦ < Dec. < 26.7◦ that were drift scanned in five consecutive days; each strip observed for 13.3 hours with a frequency range from 1 GHz to 1.5 GHz using the L-band 19-beam feed system and associated cryogenic receiver . All 19 beams had similar structures when it came to their 1/f fluctuations, which can be important for HI intensity mapping experiments due to their correlation with sky signal likely caused by foregrounds coupling with system response .

Data Analysis

To analyze this data, temporal and two dimensional power spectrum densities were estimated . Singular Value Decomposition (SVD) was then used to subtract up to twenty modes from measured noise power significantly reducing it by up to twenty modes subtraction; thus reducing knee frequency of noise in a ten MHz band to $1.8 \times10^{-3}\Hz$, well below thermal noise over a scale of five hundred seconds . The two dimensional power spectra showed that variations restricted to a small region in time frequency space could be suppressed with SVD mode subtraction; hence residual uncorrelated noise after SVD mode subtraction was uncorrelated in frequency as well . A simple noise diode calibration at eight second intervals did not affect results as the 1/f noise had a knee frequency $(f_{k}) \sim$ 6 $\times$ 10$^{-4}$Hz , time correlation spectral index $(\alpha) \sim 0.65$, and frequency correlation spectral index $(\beta) \sim 0.8$.

Findings & Implications

This study concluded that residual 1/f noise can bias HI power spectrum measurement by up to ten percent; making it important consider in HI intensity mapping experiments conducted using FAST receiver systems . The results discussed in section five provide valuable insights into characterization and mitigation of 1/f noise crucial for current optical surveys while section six summarized findings providing further insight into this topic area . Overall, this research paper provides useful information on how best characterize and mitigate 1/f noises associated with FAST receiver systems during HI intensity mapping experiments, which is essential for obtaining accurate measurements when conducting such surveys today